Roofing Contractor in Edmond, OK Built for Hail, Wind & Oklahoma Heat

When hail hits asphalt shingles, it crushes the fiberglass mat underneath and knocks off the protective granules. The bruised spot feels soft. Once the granules are gone, UV light breaks down the exposed asphalt, and that area cracks and starts leaking well before the roof should be worn out.

Hail of 1–2 inches falls across the metro almost every spring, and storms sometimes drop much larger stones. Standard 3-tab and architectural shingles aren't made to take that kind of impact over and over. Summer heat then speeds up the damage. Once the granules are gone, roof decks that run far hotter than the 95–100°F air break down the exposed asphalt quickly. Most bruising can't be seen from the ground, so homeowners often don't know it's there until a leak appears months later, sometimes close to their claim deadline.

• Heavy granule buildup in gutters or at downspout outlets
• Dark, shiny spots on shingles where granules are missing
• Dented gutters, downspouts, or metal vent caps
• Spatter marks on AC units, fences, or painted surfaces
• Soft spots that give under light pressure
• Cracked or broken skylight lenses

We see this all over Edmond after April–June storms, especially in Kickingbird, Deer Creek, and the newer subdivisions with large, exposed roof planes. Moore, Yukon and Mustang get hit by the same storm tracks again and again, so many roofs there are on their second or third hail cycle.

Our fix: We inspect each slope, photograph and measure the hits, and give you a clear report. Isolated hits can be repaired. Widespread bruising usually calls for a replacement, often with Class 4 shingles.

Shingles are held down by a strip of adhesive along the bottom edge. Strong gusts can lift the tab and break that seal. When that happens, the shingle flaps in every storm afterward, creases, and eventually tears off, leaving the underlayment exposed to wind-driven rain.

Oklahoma is one of the windiest states. Ordinary 20–30 mph gusts wear on seal strips all year, and severe storms bring straight-line winds of 60–80+ mph. Heat and cold swings make the problem worse. Adhesive softens in August and gets brittle in January, and the constant movement loosens nails. Many roofs put up quickly after big storms were also nailed too high or with too few fasteners, so wind-lifted shingles are one of the most common repairs we make.

• Shingles visibly lifted, curled, or flapping in wind
• Horizontal crease lines across shingle tabs
• Missing shingles or bare spots after a storm
• Ridge cap pieces in the yard
• Exposed nail heads or underlayment
• Water stains on upper-floor ceilings

This is most common on west- and south-facing slopes, on tall two-story homes in Oak Tree and Rose Creek, and on homes in open areas around Arcadia Lake, Piedmont and Luther, where there are few trees or neighboring houses to break the wind.

Our fix: We reseal tabs that are still sound, replace creased or missing shingles, re-nail to the manufacturer's pattern, and check the whole slope so we don't miss failures that are about to happen.

This is a sudden breach in the roof. It might be torn decking from a fallen limb, a section of shingles ripped off in a tornado or downburst, or a hole from very large hail. Water gets straight into the attic, insulation and ceilings.

In the metro, mature Bradford pears, elms and oaks grow close to houses, and ice storms and severe wind regularly bring big limbs down. Events like the May 2013 tornadoes and the October 2020 ice storm caused thousands of roof breaches at the same time. After big storms, demand spikes and materials run short, so getting a temporary tarp on fast matters a lot. Spring rain usually comes in heavy downpours, so an open roof can let in a lot of water in a single afternoon.

• Water dripping through ceilings or light fixtures
• Visible hole, punctured decking, or limb on the roof
• Sagging or bulging ceiling drywall
• Wet attic insulation
• Large sections of shingles missing
• Daylight visible from the attic

Older neighborhoods with big trees, like Downtown Edmond, the streets near UCO, Nichols Hills, Mesta Park and Heritage Hills, get the most limb damage. Moore, Yukon, Mustang and Del City see the widespread wind breaches that come with tornado-track storms.

Our fix: We tarp and seal the opening to stop water, photograph everything for your insurer, then repair the decking, underlayment and roofing once conditions are safe.

Pipe boots are rubber collars that seal around plumbing vents. Flashing is the metal that seals chimneys, walls, skylights and valleys. When either one cracks, separates, or dents, water gets in, even if the shingles are still in good shape.

Oklahoma's UV and 100°F summers break down rubber pipe boots, and many crack in 8–12 years. That's often well before the shingles around them wear out. Hail dents and pierces metal flashing and vent caps. Sudden temperature swings make metal and sealant expand and contract until joints open up. Earthquake activity in the mid-2010s and shifting expansive clay also put stress on chimneys and masonry, which can pull counter-flashing loose on older homes.

• Cracked or split rubber around plumbing vents
• Water stains around bathroom exhaust fans or vent pipes
• Rust streaks below flashing
• Gaps where chimney meets roof
• Stains on walls next to chimneys or dormers
• Dented or loose step flashing

Brick chimneys on 1970s–1990s Edmond ranches and on Guthrie Victorians fail often. Complex roofs in Coffee Creek and Fairfax, with lots of wall-to-roof transitions and dormers, have more step-flashing joints that can break down.

Our fix: We replace cracked boots with longer-lasting units and reflash or reseal chimneys, walls and skylights. We also check the decking around each opening for hidden rot.

Valleys are the channels where two roof slopes meet. During a storm they carry more water than any other part of the roof. Poor valley installation, debris buildup, or hail damage can let water run sideways under the shingles and into the house.

Edmond's newer master-planned homes have steep, multi-gable and hip roofs with a lot of valleys. Spring storms dump heavy rain in a short time, and that pushes a lot of water through those channels. Valleys also catch leaves from the oaks, pears and elms that are common here, and that debris holds moisture. Some crews installing roofs in a rush after storms cut valleys badly or skip valley underlayment, so leaks can start within a few years.

• Ceiling stains below where two roof planes meet
• Leaves and debris packed in valleys
• Cracked or cut-short shingles along the valley line
• Granule washout concentrated in valleys
• Overflowing gutters at valley outlets
• Leaks only during heavy rain

Common on large homes in Oak Tree, Fairfax, Rose Creek, Coffee Creek and Gaillardia, and on 2000s-era tract homes in Yukon and Piedmont with lots of gables. These failures tend to show up during the heaviest April–June downpours.

Our fix: We remove and rebuild the valley with ice-and-water shield underlayment and properly cut or metal-lined valleys, then clear the debris paths that feed it.

An attic without balanced intake and exhaust vents traps heat and moisture. The extra heat bakes shingles from below, so they curl, blister and turn brittle sooner. It also drives up cooling bills and can lead to condensation and mold in winter.

Summer highs in the mid-to-upper 90s, plus long stretches over 100°F, put a heavy heat load on attics here. A lot of 1970s–1990s homes were built with too little ventilation. Some were later reroofed with soffits covered over or mixed exhaust types that work against each other. In winter, quick temperature swings cause condensation on poorly vented decking. Over time, poor ventilation can take years off a shingle roof and void manufacturer warranties.

• Shingles curling or blistering before age 12–15
• Attic temperatures far above outdoor temps
• Very high summer electric bills
• Frost or damp decking in winter
• Musty attic smell or dark staining on rafters
• Painted-over or blocked soffit vents

We see it constantly in 1970s–1980s Edmond ranches, in post-war homes in Warr Acres, Bethany and Del City, and in larger two-story homes where bonus rooms leave little attic space for airflow.

Our fix: We work out the right intake-to-exhaust balance, open or add soffit vents, and install ridge vents or other exhaust that works with your roof's shape.

Out-of-town crews sometimes cut corners, like shingling over an existing roof, reusing old flashing, skipping drip edge, or nailing incorrectly. Then they leave the state. Their warranties can't be honored, and the problems show up after they're gone.

After every major hail event, out-of-state contractors flood the metro and sell door to door. Homeowners in a hurry to get their claim paid sometimes sign before checking a contractor's Oklahoma CIB registration. IRC limits allow at most two layers of shingles, and a second layer hides rotted decking. Older homes near UCO and in Bethany sometimes already have layers that should have been torn off. When those roofs fail, the surprise costs show up during the next tear-off.

• Lumpy or uneven roof surface suggesting two layers
• Old flashing or vents reused under new shingles
• Missing drip edge or starter strip
• Shingles misaligned or with exposed nails
• Contractor unreachable for warranty work
• Leaks within the first few years

This shows up most after major storm years in Moore, Yukon, Mustang and Edmond, and on older homes in Bethany, Warr Acres and Valley Brook that have been reroofed several times.

Our fix: We inspect and document the defects, then make targeted repairs or do a full tear-off down to the deck. We replace rotted boards and reinstall the roof to code.